A garage door bottom seal and weatherstripping are separate parts that close different gaps. The bottom seal is a flexible strip on the lower edge of the door that rides up and down with it and closes the gap at the floor. Weatherstripping is fixed to the frame along the sides and top of the opening, and the closed door presses against it to seal the edges.
What does the bottom seal on a garage door actually block?
The bottom seal is a strip of flexible material running the full width of the door's bottom edge, usually held in a channel called a retainer. Because it is attached to the door, the seal travels with the door each time it opens and closes. When the door comes down, the seal meets the concrete and squashes a little. That give matters. Garage floors are often not perfectly flat, and the soft seal fills low spots that a rigid door edge would leave open.
Sitting at ground level, the bottom seal deals with ground-level trouble: leaves and grit pushed in by wind, rainwater running toward the slab, and the small openings insects and rodents use. A seal in good shape cuts down on these. It does not make the floor line watertight or pest-proof.
Where does weatherstripping go on a garage door?
Garage door weatherstripping runs up both sides of the opening and across the top, mounted to the stop molding, which is the trim that frames the doorway. Most perimeter strips have a soft flap along one edge. When the door is closed, that flap presses against the face of the door and covers the thin gap between the door edges and the frame.
That edge gap is where drafts, slivers of daylight, and blown dust get in. The weatherstripping never touches the floor, and it does not move with the door. It stays on the frame and does its work only when the door face closes against it.
Why the two get treated as one, and what a gap's location tells you
Both parts are soft strips that keep out air and dirt, and casual talk often calls all of it weatherstripping. The mix-up causes trouble when someone replaces one part to fix a gap the other part is responsible for. The location of the gap is the clue.
- Light or debris along the floor line points to the bottom seal or to how the door meets the floor.
- Light or drafts up a side edge points to the side weatherstripping or to how that edge of the door sits against the frame.
- Light across the top points to the top strip.
A floor gap is not always a worn seal. If the slab dips, a bottom seal in good shape may not reach the low spot. If the door is not hanging level, one end of the bottom edge rides higher than the other, and a new seal will not close that gap. A floor gap that widens toward one end is the usual sign, and it points to the door's hardware and alignment rather than the seal.
A simple check for any season
Check during the day with the door fully closed and the garage lights off, so outside light shows through any gap.
- Look along the floor line from one end to the other, and note whether any gap is even or wider at one end.
- Look up each side edge and across the top for light, or for a flap that is curled, cracked, or pulled away.
- Write down which locations show a gap instead of calling the whole door drafty.
Seasons change what you notice. Rain shows up as water at the floor line, dusty wind leaves grit along the edges, heat can stiffen or warp strips, and cold turns a small edge gap into a draft you can feel. If a gap looks tied to the door itself, such as an uneven bottom edge or a side that no longer meets the frame, that belongs with garage door repair. You can call Plano Garage Door at (469) 491-0623 and describe which location showed the gap.
Frequently asked questions
Can a garage door have a good bottom seal and still feel drafty?
Yes. A garage door bottom seal only handles the floor line. Drafts along the sides or across the top come past the weatherstripping on the frame, or through a door edge that no longer sits snug against that weatherstripping. Checking the side and top edges separately from the floor line shows where the air is getting in.
Does the bottom seal wear differently from the side and top weatherstripping?
Usually, yes. The garage door bottom seal is pressed against concrete each time the door closes and sits in water and grit, so it tends to flatten, tear, or split at the ends. Side and top weatherstripping barely rubs against anything, so it more often dries out, cracks, or curls after long exposure to sun and temperature changes.
Does a garage door seal affect how the door opener works?
It can. The garage door bottom seal is the part that touches the floor, and an opener is set up around where the door meets the floor when it closes. A replacement seal much thicker or thinner than the old one changes that contact point, so the door may stop short or press harder against the floor. That question belongs with garage door opener service.
← All articles